The Camaro Club (UK)

heres whats left now to get rid!

Ideal to replace one in a v6/v8 82 or later its a th200c auto
Fully working when removed, I would suggest a oil and filter change when it goes back on the car.
comes with torque converter clutch, needs a kickdown cable to be complete.



Asking £50 for it, a good degrease and the box will come up nice.
Did check the pan when removed and there are no signs of clutch band wear.

Ive got quite a few chevy parts left over including:


Th350 drive shaft £40
Chevy flex plate £15
Flex fan £15
Engine mounts with part worn rubbers £10
Crank pulley £5
Water pump and pulley £15 fully working
Harmonic Balancer needing new center rubber £5

Pontiac crank pulley
£5

Trans am blower fan with A/C box type
£15

Kitt gearknob needs center button.

£15


Holley 650cfm carb in bits needing a rebuild due to leaky secondaries good for rebuild or spare parts.

£20

non swivel type chevy chrome water neck:

£5


Inlet manifold for 305

£15

Pair of engine mounts for 455 engine i think it is


And thats it for now lol!

Stu

will that manifold fit a 4 barrel carb? ive got the carb bit

I had a holley 650cfm 4 barrel with a spacer plate on, think i still have the vacuum spacer plate if ya want that with it fella?


Stu

if u have all the kit for it to run on a carb im keen, ive already got a 4 barrel that was on it

There are a couple of bolts that need to be extracted from shearing off with removal from the heads, should come out easy enough should be about £30 including postage to your door, pm me if thats of any interest to you.

Cheers

Stu