First step was to start pulling things apart to work out a shopping list of parts. I already knew I wanted the passenger outer and inner rockers, but what else would I need? The plan was to get all of the stuff I needed at once and use STS Imports to bring it all in.
A quick strip down of the interior unearthed problems with the front and rear section of the passenger floor pan and the rear inner wheel house.
(Yes - that's the rear tyre in the middle)
Drivers side rockers looked OK, and the front floor pan had been repaired a few years ago. The rear floor pan and inner wheelhouse were a different matter though, looking worse than the passenger one.
I didn't have the budget for the full lenght floor pan for both sides, so only added the inner wheel house to the list.
The front inner fenders weren't looking particulalry good either, so a pair of these were added.
A few other odds and ends were also ordered, more on those later when the time comes to fit them.