The Camaro Club (UK)

It's been a gorgeous day down here in Devon, so after taking the Camaro out for a spin I got to work!

This is before:


I then painted the light returns the correct black (as it's a z28 not an RS). Then I removed the front grill and made some mounts for my new 'show plate' and repainted the grill. Then I made some mesh inserts either side which I thought finished it off a treat. before putting it all back together again.

Finally, gave her a damn good wax:


Looks good in my opinion!! So I went and entered it into the Bude Classic Car Show in May........

Nice car, that red is really sharp.

The light returns in black look miles better. Good job

Nice work!

Might attempt something similar with the grille on my Iroc, personally I reckon these look better without the fog lights.

Cheers!

I carried on afterwards and made cut-outs and then added mesh grills to the bonnet bulges as well, so they look like they actually do something. Then I replaced the ugly square aftermarket rear fog light with a slimline LED one and wired it into the original front fog light switch to keep it looking original inside. The old rear fog light had a large 'halfords' type switch which I removed as it was so bl**dy ugly.

Have also ordered clear side repeater lenses and new front driving lights to tidy it up a bit more:-)

Good photo's there The light returns in black certainly work, there's more attitude with the front end

Which wax did you use?