The Camaro Club (UK)

Online Community for all Camaro Owners and enthusiasts
It is currently Wed Nov 06, 2024 1:26 am

All times are UTC




Post new topic Reply to topic  [4 posts ] 
Author Message
 Post subject: Starting help?
PostPosted:Sun Feb 07, 2016 3:06 pm 
Offline
Big Block
User avatar

Joined:Tue Feb 23, 2010 12:40 pm
Posts:3245
Car Details:'79 Camaro, 350 V8
Location:South Bucks
Any ideas as to what can be going on with the below?

When i turn the key to acc/ run, everything lights up, volts gauge shows correct voltage etc. When i turn the key to start, you can hear a click at the starter but everything dies out, all of the dash cuts out. Then when you take the key out and put it back and turn it, nothing happens. Not even the dash lights come on this time, volt gauge doesn't work either.

You have to disconnect the battery for a few seconds, reattach it and then then the dash lights work again as normal, and when you turn the key to start, you hear a click again and everything dies out. And you just repeat the loop over and over. Any ideas?

I thought at first it was the starter motor and it was drawing too many amps or something, so i switched it out to a starter motor that i knew was working 100% and started a car each time with no problems. The battery is only a few months old and is over spec... 750cca. Really stuck on this one :tired:

Cheers!

_________________
How to post pics: When writing a message, scroll down and use the "attach file" option. Where possible, a photo sharing service can be used such as Flickr, Imgur etc. The image location (usually ending in .jpg) can be copy and pasted between the ][ brackets that appear when you click the 'Img' button (you can find this button at the top of the message box).

How to post youtube vids: Click on the 'youtubeHD' button at the top of the message box and in the middle of the ][ brackets that just appeared, copy and paste everything from the youtube web address that appears after the = sign i.e if this is the url: https://www.youtube.com/watch?v=K2cNqaPSHv0 just copy "K2cNqaPSHv0").


Top
   

Starting help?

Sponsor

Sponsor
 

 Post subject: Re: Starting help?
PostPosted:Sun Feb 07, 2016 3:33 pm 
Offline
Big Block
User avatar

Joined:Sat Jun 28, 2014 6:55 pm
Posts:808
Location:Croxley Green, Hertfordshire
Bad connection somewhere , how about the engine earth strap that goes to the chassis?

_________________
1997 30th Anniversary SS SLP
1993 GMC Typhoon


Top
   
 Post subject: Re: Starting help?
PostPosted:Sun Feb 07, 2016 6:35 pm 
Offline
Big Block
User avatar

Joined:Tue Feb 23, 2010 12:40 pm
Posts:3245
Car Details:'79 Camaro, 350 V8
Location:South Bucks
I have to check the strap, i'm sure it was on there but will double check. The wires on the starter i know are good as i hooked them up carefully and made sure they were tight. So must be further up the chain. What i don't get is why everything cuts out and as soon as you unhook and reconnect the battery lead, everything's fine again until you try starting it. Very odd. Will investigate the ground strap...

_________________
How to post pics: When writing a message, scroll down and use the "attach file" option. Where possible, a photo sharing service can be used such as Flickr, Imgur etc. The image location (usually ending in .jpg) can be copy and pasted between the ][ brackets that appear when you click the 'Img' button (you can find this button at the top of the message box).

How to post youtube vids: Click on the 'youtubeHD' button at the top of the message box and in the middle of the ][ brackets that just appeared, copy and paste everything from the youtube web address that appears after the = sign i.e if this is the url: https://www.youtube.com/watch?v=K2cNqaPSHv0 just copy "K2cNqaPSHv0").


Top
   
 Post subject: Re: Starting help?
PostPosted:Sun Feb 07, 2016 7:04 pm 
Offline
Big Block
User avatar

Joined:Sat Jun 28, 2014 6:55 pm
Posts:808
Location:Croxley Green, Hertfordshire
If you have a bad connection on the power side it will arc and get hot when you try to draw current through it, the arcing and heat will make the connection bad and give the fault you describe. Could be its just the time taken when you remove the battery that allows it to cool and go from being an impossible connection back to a bad one. I would remove the positive and neg power lead connections and clean the area they bolt to with a wire brush and replace them(unless you haven't put the strap back on ) I you don't have the strap from the battery or chassis on correctly (clean and tight) when you are turning the engine over its trying to draw all those starting amps through all the wiring loom connections which would give the problems you are describing. I'm confident it's something simple

_________________
1997 30th Anniversary SS SLP
1993 GMC Typhoon


Top
   
Display posts from previous: Sort by 
Post new topic Reply to topic  [4 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited