The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

Welding / altering steel wheels
http://classiccamaroclub.mfatw.com/viewtopic.php?f=9&t=4679
Page 1 of 1

Author:  78 Camaro [Wed Sep 30, 2015 4:43 pm ]
Post subject:  Welding / altering steel wheels

Just wondering - i have 10.5" steel wheels in chrome and the backspacing is 4". There is minimal clearance to the outer lip and i'd like to tuck the wheel in more (ideally be 1.5", maybe even 1.75"). Is there a place that would be able to separate the drum from the mounting face and reweld? I had a jeep once that i was told had reversed rims (stock steel wheels and they cut the welds and rewelded for a deep dish). Was done before i got it but didn't appear to have an issue. I've got 7.5" rims on there now with a 255 but it looks a bit too tucked in. Thinking of getting 1" spacers, but then i thought about doing something to the wheels as i can't really use them the way they are. Cheers!

Author:  chevy-stu [Fri Oct 02, 2015 5:37 pm ]
Post subject:  Re: Welding / altering steel wheels

A lot of the Veedub guys use 'banded' steel wheels, so maybe search a few Beetle type places... Might not be economically viable tho.. :think:

Author:  78 Camaro [Tue Oct 06, 2015 12:23 pm ]
Post subject:  Re: Welding / altering steel wheels

Thanks Stu, i'll see if i can find a place and find out their costs to see if it's worthwhile. The wheels are good but just don't have enough backspace (4"). I'll report back if i find anything decent...

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/