The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

Measurement needed please
http://classiccamaroclub.mfatw.com/viewtopic.php?f=9&t=2531
Page 1 of 1

Author:  78 Camaro [Sun Sep 30, 2012 11:58 pm ]
Post subject:  Measurement needed please

Hi all,

Hoping to get a measurement from 2nd gens please - Looking at the gap between the top of the door and the A pillar. I'm trying to line up the fender but not sure if the door is too low. I've already forgotten what the caliper gauge said but i think it was about 9mm

This is the bit i mean:
Attachment:
Screen shot 2012-09-30 at 23.57.53.png
Screen shot 2012-09-30 at 23.57.53.png [74.95KiB |Viewed 867 times ]
Cheers!

Ray

Author:  chevy-stu [Mon Oct 01, 2012 7:01 pm ]
Post subject:  Re: Measurement needed please

Hi Ray..

Mine's 12mm drivers side, 9mm passenger side... (but the panel fit on mine is shocking cos' of all the action it gets.. :roll: )

I'm sure I read on Nasty Z28 about hanging panels that your supposed line the door with the rear quarter and sill, then mount the front wing against the door etc...

Author:  evilzee28 [Tue Oct 02, 2012 8:41 am ]
Post subject:  Re: Measurement needed please

Hi Ray, as Stu says always gap from the 1/4 panel/sills to the door as the 1/4 & sills are fixed & constant. Make sure that the swage line that runs down the centre of the door lines up with the one on the 1/4. The gap to the sill is normally around 7 mm or so. The gap between door & 1/4 would also be around 7-8 mm hth

cheers...Nige

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/