The Camaro Club (UK)

Hi all,

Hoping to get a measurement from 2nd gens please - Looking at the gap between the top of the door and the A pillar. I'm trying to line up the fender but not sure if the door is too low. I've already forgotten what the caliper gauge said but i think it was about 9mm

This is the bit i mean:
Cheers!

Ray

_________________
How to post pics: When writing a message, scroll down and use the "attach file" option. Where possible, a photo sharing service can be used such as Flickr, Imgur etc. The image location (usually ending in .jpg) can be copy and pasted between the ][ brackets that appear when you click the 'Img' button (you can find this button at the top of the message box).

How to post youtube vids: Click on the 'youtubeHD' button at the top of the message box and in the middle of the ][ brackets that just appeared, copy and paste everything from the youtube web address that appears after the = sign i.e if this is the url: https://www.youtube.com/watch?v=K2cNqaPSHv0 just copy "K2cNqaPSHv0").

Hi Ray..

Mine's 12mm drivers side, 9mm passenger side... (but the panel fit on mine is shocking cos' of all the action it gets.. )

I'm sure I read on Nasty Z28 about hanging panels that your supposed line the door with the rear quarter and sill, then mount the front wing against the door etc...

_________________
“You only live once, but if you do it right, once is enough.”

Hi Ray, as Stu says always gap from the 1/4 panel/sills to the door as the 1/4 & sills are fixed & constant. Make sure that the swage line that runs down the centre of the door lines up with the one on the 1/4. The gap to the sill is normally around 7 mm or so. The gap between door & 1/4 would also be around 7-8 mm hth

cheers...Nige

_________________
Too much power...not enough hands!!