The Camaro Club (UK)

Online Community for all Camaro Owners and enthusiasts
It is currently Fri Nov 22, 2024 10:23 pm

All times are UTC




Post new topic Reply to topic  [6 posts ] 
Author Message
PostPosted:Mon Sep 12, 2011 1:48 pm 
Offline
Big Block

Joined:Sat Aug 23, 2008 11:47 pm
Posts:87
Car Details:1998 Camaro, V6 3.8, Auto, Red, T-Tops
Location:Scotland
Its me again, another minor problem,

Wondering if anyone has had a similar problem to this?
I think I know where the water is coming from, just don't know how to stop it!!
When its been raining and you open the boot (trunk), water slids off into two channels on each side of the car inside the boot, which then runs off down into the space where the lights are located.
Seems a weird way place to drain it to, but.....
Any ideas anyone??

Kind Regards
DS


Top
   

Rear lights filling with water....sometimes!!

Sponsor

Sponsor
 

PostPosted:Mon Sep 12, 2011 4:55 pm 
Offline
Big Block
User avatar

Joined:Sat May 15, 2010 2:16 pm
Posts:264
Car Details:1999 (Registered as New 2001) Black 3.8 V6 Targa Top
Location:March, Cambridgeshire
Mine does exactly the same, I'm sure it's designed that way and is not a problem. When it's raining it's always best to park on a level is you can but if not have the rear end going down hill otherwise if it's a real downpour and your parked with the front faceing downhill the water cannot run away and runs inside the boot area by the rear speakers.

Hope this is of any use.

Cheers Gerry

_________________
Cheers Gerry


Top
   
PostPosted:Mon Sep 12, 2011 7:39 pm 
Offline
Big Block

Joined:Fri Aug 06, 2010 7:51 pm
Posts:255
Hi

Similar prob!

It seems to get into the trunk lid - either side there seems to be a join about 1/2 way along. I get the same problem when I wash it.

Temporary cure - only open the lid a few inches and let it drain into the body channels. It then drops through the gap at the back above the light units.

Permanent cure, not sure yet - maybe some clear mastic into the joins?? Clear mastic into the light units - Have to say though I get no water in my lights.

Any thoughts?? :? :? :?


Top
   
PostPosted:Mon Sep 12, 2011 9:21 pm 
Offline
Big Block
User avatar

Joined:Thu Apr 07, 2011 10:06 pm
Posts:295
Car Details:89 RS V6 Camaro Moggy Traveller with Fiat two litre twincam 35 Standard flying 12 To be Rodded ????
Location:middlesbrough North East
Hi seen similar problem on other yanks if you can coat the top of the light with clear silicone (lay a bead of silicone dip your finger in soapy water and smooth it on the join in the lens ) and with a very small drill bit drill a very small hole in the bottom of the lens on the outside ,then if any more water dose get in it can drain out and also stop it condensating inside of light hope this helps Cheers Neil :thumbup: PS make sure that its bone dry before putting on the silicone.


Top
   
PostPosted:Tue Sep 13, 2011 10:37 am 
Offline
Big Block

Joined:Sat Aug 23, 2008 11:47 pm
Posts:87
Car Details:1998 Camaro, V6 3.8, Auto, Red, T-Tops
Location:Scotland
Good advice guys, thank you all. :thumbup:

Kind Regards
DS


Top
   
PostPosted:Sat Oct 15, 2011 11:25 am 
Offline
Small Block

Joined:Thu Apr 23, 2009 6:48 pm
Posts:24
Car Details:97 5.7 z28 camaro, magnaflow stainless exhaust, 18 and 20" chrome american racing wheels.
i had a rear light that was filling with water, as i couldn't find where it was getting in I drilled a small hole in the bottom of the light so it could run out which worked a treat!


Top
   
Display posts from previous: Sort by 
Post new topic Reply to topic  [6 posts ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 60 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited