The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

Unshaving The Shaved Door Handles
http://classiccamaroclub.mfatw.com/viewtopic.php?f=5&t=5221
Page 1 of 1

Author:  3rdGenmalc [Mon Apr 03, 2017 9:31 pm ]
Post subject:  Unshaving The Shaved Door Handles

Finally had to give in to "the man", they told me last year "Get door handles back on this car".

So here I go......hate it....hate it....hate it....hate it.... :thumbdown:

Image

Image

Author:  chevy-stu [Mon Apr 03, 2017 11:19 pm ]
Post subject:  Re: Unshaving The Shaved Door Handles

official instruction from the spanish car police ?

Author:  3rdGenmalc [Tue Apr 04, 2017 7:51 am ]
Post subject:  Re: Unshaving The Shaved Door Handles

Yup....no more MOT until it has "a mechanical means of opening the doors from the outside".

If I lock the doors from the inside, me in it, the doors cannot be opened.
Back to square one are'nt we ?

Author:  78 Camaro [Tue Apr 04, 2017 10:12 am ]
Post subject:  Re: Unshaving The Shaved Door Handles

Oh dear, that's not good :( I kind of see their point BUT c'mon :/

Good at least that the handles weren't cut out and plate welded over them, looks recoverable?

Author:  3rdGenmalc [Wed Apr 05, 2017 1:00 pm ]
Post subject:  Re: Unshaving The Shaved Door Handles

I had to take the car back and have them do the paint again.
You could till see where the mirrors were attached and the front
of the driver´s door was just fogged.
The passenger door had a huge curtain like run on it.

All done nice now, installed the outer weatherstrip and mirrors yesterday.

Author:  chevy-stu [Thu Apr 06, 2017 11:12 am ]
Post subject:  Re: Unshaving The Shaved Door Handles

what a pain.... guess rules in spain are pretty strict on some stuff

Author:  3rdGenmalc [Thu Apr 06, 2017 11:27 am ]
Post subject:  Re: Unshaving The Shaved Door Handles

Now I´ve got to get my fat hands into small places to install the locks, handles and rods... :lolno:

Author:  3rdGenmalc [Thu Apr 13, 2017 10:12 am ]
Post subject:  Re: Unshaving The Shaved Door Handles

Job and a half, so far only the driver´s door is all hooked up passenger door today.
"Luckily" I decide to leave the lock off the passenger door.....turns out I´ve lost one of my
original lock cylinders which must give up an arm off the back to the new ones.
I still wish I could find it though.

Here we are.....these handles are dreadful.. :thumbdown: ..no thought little design.

Image

Image

Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/