| The Camaro Club (UK) http://classiccamaroclub.mfatw.com/ |
|
| Light smashed replacement needed - any ideas please? http://classiccamaroclub.mfatw.com/viewtopic.php?f=5&t=2462 |
Page 1 of 1 |
| Author: | Lennyp [Sat Aug 25, 2012 10:14 pm ] |
| Post subject: | Light smashed replacement needed - any ideas please? |
Hi, I was in a service station today when a complete muppet reversed into my front end and smashed one of my lights on my Iroc. Can anyone tell me where I can get a replacement glass? It wasn't the headlight by the way it is one of the little driving lights in my nose - the ones with the handed glass lenses. Also while I am here can anyone suggest a source of indicator/side light lenses? Mine have filled with water and gone foggy. Any help appreciated, Alena |
|
| Author: | matty0785 [Sat Aug 25, 2012 10:17 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
speak to this guy who is local to me and breaks third gens http://www.ebay.co.uk/itm/Chevrolet-Cam ... 014wt_1037 |
|
| Author: | neil.w [Thu Aug 30, 2012 8:16 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Hi Alena did you get your glass and sidelight/indicators ?if not a cheap fix ,take out your side lights drill a hole in the bottom clean up the lenses flat them off with a scotchbrite pad and tint them ,you can buy tins cheap enough .If your lights are working fine of course hope this helps Cheers Neil 
|
|
| Author: | Lennyp [Fri Aug 31, 2012 12:02 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Sadly not had any luck on either front as yet. I will keep an eye on ebay, if not I think I might try ordering something from the states. |
|
| Author: | Rocky [Fri Aug 31, 2012 10:35 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Are you after the fog light in the centre grill? |
|
| Author: | Lennyp [Tue Sep 11, 2012 1:42 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Yes that is the one - the drivers side has been smashed. If I can't get an original one I will look at getting some aftermarket ones but I did want to keep her as close to the original spec as possible. |
|
| Author: | 3rdGenmalc [Sun Jan 13, 2013 5:43 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Have you tried Bauer Millet, Parts 0161 872 7744 ? I used to get lots of parts from them, had a real good parts man. Sadly he left and the service was never the same after. In the US http://www.hawksthirdgenparts.com/categ ... omponents/ |
|
| Author: | Lennyp [Sun Jan 13, 2013 8:20 pm ] |
| Post subject: | Re: Light smashed replacement needed - any ideas please? |
Thanks for the replies. I managed to get some very similar aftermarket fog lights to replace both at the same time. I will keep looking! I am off to the States soon to do route 66 so will be keeping an eye out for breakers on the way!! |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|