| The Camaro Club (UK) http://classiccamaroclub.mfatw.com/ |
|
| removing egr and emission kit http://classiccamaroclub.mfatw.com/viewtopic.php?f=4&t=3658 |
Page 1 of 1 |
| Author: | bigtalljim [Fri Jan 17, 2014 6:34 pm ] |
| Post subject: | removing egr and emission kit |
I am upgrading to 4bbl carb n manifold to replace old 2bbl carb etc. Question is can and how do I remove all emission and egr bits. What do I plug etc. Rocker cover vents too? |
|
| Author: | Pa's F-bodies [Sun Jan 19, 2014 12:24 pm ] |
| Post subject: | Re: removing egr and emission kit |
Not sure what set up you've got but you can take most of it away, but I would not remove the PCV valve from the rocker covers or you may find that your rear oil seal will leak a little oil. |
|
| Author: | chevy-stu [Sun Jan 19, 2014 2:06 pm ] |
| Post subject: | Re: removing egr and emission kit |
Just put a breather on on rocker cover, and a PCV to the carb on the other. I'm guessing everything else can just be removed and plugged if you're going aftermarket 4 barrel. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|