The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -
http://classiccamaroclub.mfatw.com/viewtopic.php?f=33&t=4527
Page 1 of 2

Author:  scottaok1234 [Mon Jun 08, 2015 5:43 pm ]
Post subject:  THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

HI all .. just thought to share my project with you all as once its all done it will be up for sale - and it wont take long by the seems of it . EVEN FROM TODAY I DONT KNOW IF ITS AN IROC ? Z28 ? ANY IDEAS PLEASE ..


its had a huge amount of work done and a lot of time and money already spent on it as listed below - and il load just some of the pics taken some weeks back to give examples of it - and the mechanic is german and has serviced all my cars for some time and he loves to customize American vehicles into one offs so your mates having got what you have - - I can pass details for you to him if need be -- we are from outer London


brand new Lamborghini Gallardo exhaust + 2 x twin exhaust tips - costing £5333.00 yes 5k

had to have the boot re made to accept the exhaust - £450

brand new progressive wheels at £1250.00

4 x brand new white writing raised letters tyres costing £466

engine fully serviced and lots added costing many hundreds

having a full respray - gloss black with AA orange bottom half costing £1800

brand new holley carb and fitted costing £300

some repairs and small dents repaired costing £490

replaced brake pipes and other parts underneath her

brand new high torque starter motor being fitted as we speak costing £250

bodywork being smoothed over (( wings to bumper )) £385.00

bodywork rear areas being smoothed over and also front grille holes being smoothed over a few hundred again .

brand new green ( prism ) under car green neon light kit going to be fitted £150

original rear lights but now slight smokey looking ..

brand new discs and pads etc - costing quite a fair bit

all new engine gaskets throughout engine etc

new inner wing plastic parts

having the word ( Camaro ) inserted into bumper with red light bar behind Perspex so it comes on with the brake lights -- being done as we speak

im sure lots more will go into this but so far around £13k upwards and more to follow and that's without the car value to start with .

im sure its not the best by far but in the hope it will be a slight one off with a few of the bits being added and being done .

im having fun having it all done and the garage will provide full receipts for everything too and I also have the receipts for the bits listed above already all from the dealers for parts and work from garage too --

it was just a project I took on and il swap it for an older type mustang or a vehicle and cash my way or a campervan - I might also consider a motorcycle in part ex also -- who knows -- anything in the world could take my fancy - ((( cash either way for the right deal )))

Attachments:
File comment:NEW BRAKE DISCS AROUND CAR
10986505_10206497459936233_8346783970147704982_n.jpg
10986505_10206497459936233_8346783970147704982_n.jpg [46.52KiB |Viewed 1079 times ]
11393143_10206497625020360_2741511630823690189_n.jpg
11393143_10206497625020360_2741511630823690189_n.jpg [119.98KiB |Viewed 1079 times ]
File comment:PROGRESSIVE WHEELS
1499573_10206497621220265_5781791811334982781_n.jpg
1499573_10206497621220265_5781791811334982781_n.jpg [57.36KiB |Viewed 1079 times ]
File comment:GALLARDO EXHAUST
10421201_10206076907142676_8653125055600194654_n.jpg
10421201_10206076907142676_8653125055600194654_n.jpg [49.51KiB |Viewed 1079 times ]
IMG_2650.PNG
IMG_2650.PNG [312.47KiB |Viewed 1079 times ]

Author:  scottaok1234 [Mon Jun 08, 2015 6:05 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

Quote:
HI all .. just thought to share my project with you all as once its all done it will be up for sale - and it wont take long by the seems of it . EVEN FROM TODAY I DONT KNOW IF ITS AN IROC ? Z28 ? ANY IDEAS PLEASE ..


its had a huge amount of work done and a lot of time and money already spent on it as listed below - and il load just some of the pics taken some weeks back to give examples of it - and the mechanic is german and has serviced all my cars for some time and he loves to customize American vehicles into one offs so your mates having got what you have - - I can pass details for you to him if need be -- we are from outer London


brand new Lamborghini Gallardo exhaust + 2 x twin exhaust tips - costing £5333.00 yes 5k

had to have the boot re made to accept the exhaust - £450

brand new progressive wheels at £1250.00

4 x brand new white writing raised letters tyres costing £466

engine fully serviced and lots added costing many hundreds

having a full respray - gloss black with AA orange bottom half costing £1800

brand new holley carb and fitted costing £300

some repairs and small dents repaired costing £490

replaced brake pipes and other parts underneath her

brand new high torque starter motor being fitted as we speak costing £250

bodywork being smoothed over (( wings to bumper )) £385.00

bodywork rear areas being smoothed over and also front grille holes being smoothed over a few hundred again .

brand new green ( prism ) under car green neon light kit going to be fitted £150

original rear lights but now slight smokey looking ..

brand new discs and pads etc - costing quite a fair bit

all new engine gaskets throughout engine etc

new inner wing plastic parts

having the word ( Camaro ) inserted into bumper with red light bar behind Perspex so it comes on with the brake lights -- being done as we speak

im sure lots more will go into this but so far around £13k upwards and more to follow and that's without the car value to start with .

im sure its not the best by far but in the hope it will be a slight one off with a few of the bits being added and being done .

im having fun having it all done and the garage will provide full receipts for everything too and I also have the receipts for the bits listed above already all from the dealers for parts and work from garage too --

it was just a project I took on and il swap it for an older type mustang or a vehicle and cash my way or a campervan - I might also consider a motorcycle in part ex also -- who knows -- anything in the world could take my fancy - ((( cash either way for the right deal )))


Attachments:
11068293_10206000533113373_7190146914965667591_n.jpg
11068293_10206000533113373_7190146914965667591_n.jpg [50.57KiB |Viewed 1081 times ]
4d5 fg6hj.jpg
4d5 fg6hj.jpg [44.46KiB |Viewed 1081 times ]
[OJHIPBOU.jpg
[OJHIPBOU.jpg [106.12KiB |Viewed 1081 times ]
File comment:ENGINE AT THE MOMENT
f6g8bn.jpg
f6g8bn.jpg [44.92KiB |Viewed 1081 times ]
File comment:HIGH TORQUE STARTER MOTOR
11071513_10206369106007465_4998186964869978928_n.jpg
11071513_10206369106007465_4998186964869978928_n.jpg [34.15KiB |Viewed 1081 times ]

Author:  scottaok1234 [Mon Jun 08, 2015 6:11 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

A FEW MORE PICS ALSO ---- HOPE IM DOING THIS RIGHT AS NEVER DONE THIS BEFORE HAHA

Attachments:
PKJONBL.jpg
PKJONBL.jpg [350.57KiB |Viewed 1081 times ]
4d5  GDS GDSS.jpg
4d5 GDS GDSS.jpg [64.9KiB |Viewed 1081 times ]
R GE ARGAER#.jpg
R GE ARGAER#.jpg [60.33KiB |Viewed 1081 times ]
SDG#.jpg
SDG#.jpg [66.54KiB |Viewed 1081 times ]

Author:  scottaok1234 [Mon Jun 08, 2015 6:13 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

as the work continues il keep uploading and should be completed in just weeks now - thanks for watching

Author:  Twistedsanity [Mon Jun 08, 2015 7:20 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

Hi and welcome, ill be watching this thread with interest over the coming weeks, from your expenditure list I hope your doing this for the love of it and not hoping to make a profit when it's done!

Author:  scottaok1234 [Mon Jun 08, 2015 9:31 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

Hi there -- thanks for showing interest . and yes its all for pure love and fun - im going to do a mustang after and cut a Bentley into a pickup -- cant wait -- I just love the fun of it all --

it will then go to ebay and fetch what it fetches -- I see the average Camaro fetching £4500 - £5500 just plain standard and all needing a little work so I would like to think id get a touch more and I know il be looking near double this or close to it or it can go back to America maybe who knows :)

I love the car and its going to a few shows in the next few months and magazines also and then it will be ready to go -

once again thanks for your kind interest

Author:  Twistedsanity [Tue Jun 09, 2015 7:29 am ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

Cool' I am curious as to why you used a Lamborghini exhaust on a camaro? Did you have it laying about and needed a use for it? I have to admit I love the idea of making a Bentley pick up even if it's just to piss off the Bentley owners club posse , have you seen the drag racing Bentley that appeared on the scene last year ?

Author:  chevy-stu [Tue Jun 09, 2015 1:39 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

Interesting project and great to see lots of personal touches.. A lot of them aren't going to be to everybody's taste, but that's not the point, if you like it that's what count..

I'm a little confused if you're continuing with the project, or looking to sell it on as it is now.. ???? :crazy:

Author:  scottaok1234 [Tue Jun 09, 2015 11:39 pm ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

hi -- I will be finishing the car and then it will go on web auction e.b.a.y or so .......... I am enjoying getting it all done I must admit . its great fun

Author:  bnc47 [Tue Jul 07, 2015 11:24 am ]
Post subject:  Re: THE MAKING & BRINGIONG BACK TO LIFE MY CAMARO 3RD GEN -

4.8 V8, is it a Chevy engine?
De-stroked maybe?
Or am I showing my ignorance of Camaro engine cubes?

Page 1 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/