The Camaro Club (UK)

Online Community for all Camaro Owners and enthusiasts
It is currently Fri Nov 01, 2024 2:36 am

All times are UTC




Post new topic Reply to topic  [1 post ] 
Author Message
PostPosted:Fri Apr 12, 2019 8:15 pm 
Offline
Small Block

Joined:Thu Feb 07, 2019 12:28 pm
Posts:28
Car Details:N/A - ATM
Hello all, sorry to bother you again.
I wondered if anyone has any feedback on the following?

So my 69 Camaro is still having interesting brake set up issues.

I have a 1.25mm end float on the drivers side half shaft.
I wonder if the C Clip that locates the half shaft is worn as I don't think there should be any, but don't know where to try and check this out?

It has a 12 Bolt rear end.
Axle tubing O.D is 2.98, and top measurement is 3.124.
Also I reckon offset is circa 2.9,

If anyone knows about the drive shaft play and can advise that would be great?

Thanks all.

Desperately trying to get up and running for late spring / early summer and this is the last hurdle.


Top
   

Rear axlw / half shaft advice

Sponsor

Sponsor
 

Display posts from previous: Sort by 
Post new topic Reply to topic  [1 post ] 

All times are UTC


Who is online

Users browsing this forum: No registered users and 27 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Limited