The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

oil pressure reading
http://classiccamaroclub.mfatw.com/viewtopic.php?f=3&t=3716
Page 1 of 2

Author:  farl cogetty [Wed Feb 12, 2014 7:32 am ]
Post subject:  oil pressure reading

what is ideal ???
mine is around 40 at start as if it is stuck but once warm idle is about 20 then rises with revs as normal...
this ok

Author:  3rdGenmalc [Wed Feb 12, 2014 8:22 am ]
Post subject:  Re: oil pressure reading

I find searching for answers on this kind of thing gives you many many varied theories.
But try this thread,
http://www.hotrodders.com/forum/correct ... 59581.html

"You need at least 10 lbs. of oil pressure for
every 1000 rpm's. Ideal is around 15-20 lbs
per 1000 rpm's."

Author:  chevy-stu [Wed Feb 12, 2014 10:32 am ]
Post subject:  Re: oil pressure reading

I thought it should 25/30 at warm idle. Mine sits around 30 at lowest, but it's a newish engine with some clever bits.

20 sounds a little low. You have got a Chevy engine in yours haven't you ?

Author:  farl cogetty [Wed Feb 12, 2014 11:04 am ]
Post subject:  Re: oil pressure reading

a poncho....... but I think 20 is ok and use Valvoline racing stuff .....
bit worried how it sticks around 40 when cold but people tell me thats fine :eh:

Author:  3rdGenmalc [Wed Feb 12, 2014 12:14 pm ]
Post subject:  Re: oil pressure reading

I have a high volume pump in mine, I see people saying it´s not a good thing but I´ve had it in there a long time no problems.
I think for low rpm use it keeps the top of the engine well oiled.
I see 50-60.

Author:  farl cogetty [Wed Feb 12, 2014 5:49 pm ]
Post subject:  Re: oil pressure reading

Quote:
I see people saying it´s not a good thing .
in my opinion there's too many opinions in hot rodding :lolno:

Author:  Pa's F-bodies [Wed Feb 12, 2014 6:36 pm ]
Post subject:  Re: oil pressure reading

May be your oil is a bit thin what grade are you using?

Also gauges are not always that accurate.

I think from memory that a Pontiac motor when warm should read 30 psi at 2000rpm

40psi at cold is ok :thumbup:

Author:  farl cogetty [Wed Feb 12, 2014 7:01 pm ]
Post subject:  Re: oil pressure reading

30@2000 is about right :thumbup:

I use
http://www.ebay.co.uk/itm/Valvoline-VR1 ... 43bcd40446

was recommended kendall but its too expensive

Author:  sportsroof [Wed Feb 12, 2014 7:14 pm ]
Post subject:  Re: oil pressure reading

Most of the engines I deal with (plus my own) are around 60-80psi cold but drop to about 30 ish when hot idling, rising to around 60ish at moderate rpm. HTH
Cheers, Martin

Author:  Z28DUNC [Thu Feb 13, 2014 10:18 am ]
Post subject:  Re: oil pressure reading

Mine doesn't drop below 38. Usually 45 to 55 driving when warm. 60 ish when started from cold.

But thats a LS1. My old LT1 had crap oil pressure in comparision. 20ish or lower when warm at idle but was fine when driving? I think it was something to do with a sticky EGR valve.

On a side note I was stuck in traffic in the Camaro last night and the engine temp and oil temp didn't move a jot. Well chuffed. Stayed just below 210 F and oil pressure a steady 38 at idle.

Page 1 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/