The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

67 Camaro fuel tank needed anyone have one....
http://classiccamaroclub.mfatw.com/viewtopic.php?f=16&t=2447
Page 1 of 2

Author:  Russ D [Fri Aug 17, 2012 5:41 pm ]
Post subject:  67 Camaro fuel tank needed anyone have one....

Just found a hair line crack in my fuel tank, is it USA or can I get one in the UK?

Thanks

Russ.

Author:  70 z28 [Fri Aug 17, 2012 8:37 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

hi mate weld it up i did mine on my 70 :thumbup:

Author:  neil.w [Fri Aug 17, 2012 9:17 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Hi Russ if you take your tank off give it a good clean and check over if it is just cracked then it can be welded up also as a double fix you can put tank sealor into it , i have used this several times and always been happy Cheers Neil :thumbup: any questions don,t hesitate .

Author:  Russ D [Fri Aug 17, 2012 11:06 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Is the tank sealer that chemical metal two part putty that you need together?
Thanks chaps.

Author:  neil.w [Fri Aug 17, 2012 11:22 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

No the tank sealor is a liquid that you tip into your tank once its out ,if it is cracked and not peppered (loads of little holes ) it could be welded ,where abouts is the crack .To make any long lasting repair it will need to be empty and off the car.Cheers Neil :thumbup:

Author:  Russ D [Sat Aug 18, 2012 12:08 am ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

looking from the back its at the back rh corner where it begins to round up to the floor of the car. I bust a wheelie bar and it came up and smacked it creasing the metal slightly, the crack is on the pinnacle of the crease.

Author:  78 Camaro [Sat Aug 18, 2012 2:51 am ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Hi Russ,

I replied to your other thread about this. I recently fixed a hole in my tank. too scared to weld it, so as my other post explains, i sandwiched in the hole between 2 small steel plates. Just cut out 1"x2" piece of steel, placed one on the inside, one on the inside, with a bolt through the midddle. Tightening the nut created a physical barrier. As a failsafe i used plastic padding leak stop that i got from halfords between the plates to create a gasket, just in case. I spoke on the phone with plastic padding - they cautioned me on the use of the fuel tank repair paste they do, because since ethanol content has gone up in fuel, it will start to break down the current chemical compound, so they are looking at re-formulating, but a new product will be a while off. the leak stop apparently works better, which is what i used. they are both 2 part - 1 tube paste, 1 tube hardener. I would create as much of a physical barrier as possible, hence my sandwhich method. Depending on your situation, maybe a similar solution can be put in place. The same guy from plastic padding also mentioned that some people would just drill out a bigger hole and and screw a bolt in, making the hole kinda like how the oil sump plug is. Hopefully that helps in someway!

Cheers,
Ray

Author:  Russ D [Sat Aug 18, 2012 12:24 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Thanks Ray.

Author:  neil.w [Sat Aug 18, 2012 5:31 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Hi Russ to fix your tank correctly it needs welding (with it beeing a crack ) have you got your tank off ? Nice to see your car at Donnie but didn,t see you only to pick up you trophy :clap: nice one mate .Car looks as sweet as ever i to grew up looking at your car and cars of theese times. Any problems with your tank P.M. me ,im in Middlesbrough Cheers Neil :thumbup: im guessing your not to far away ?

Author:  Russ D [Sat Aug 18, 2012 9:08 pm ]
Post subject:  Re: 67 Camaro fuel tank needed anyone have one....

Hi Neil, thanks for that, Im in wakefield west yorks, you should have come over at Donnie - just asked anyone for the greying slightly bald fat bloke who's stuck in 79 and can't get out!! :lolno:

Page 1 of 2 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/