The Camaro Club (UK)
http://classiccamaroclub.mfatw.com/

Anyone breaking a 76-81 Camaro?
http://classiccamaroclub.mfatw.com/viewtopic.php?f=16&t=1963		 Page 1 of 1
Author:  flak monkey [Mon Sep 12, 2011 2:27 pm ]
Post subject:  Anyone breaking a 76-81 Camaro?
I am after several little bits that aren't available new or repro, so anyone breaking a late second gen in the UK at the moment?

Thanks :)
Author:  chevy-stu [Mon Sep 12, 2011 6:54 pm ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
I bought some bits from a guy breaking a rotten purple 77' in Surrey... What do you need ?
Author:  flak monkey [Mon Sep 12, 2011 7:29 pm ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
Some bits of floor - the bits under the rear seats where they meet the inner arches. So if it was rotten probably unlikely they will be any better than mine :(

And some other sheet metal bits from around the screen.
Author:  70 z28 [Wed Sep 14, 2011 11:10 pm ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
hi witch bits do you need from around the screen because i no were theres a 79 camaro shell and i will check on the floor for you thanks shaun :thumbup:
Author:  flak monkey [Thu Sep 15, 2011 7:58 am ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
Thanks Shaun :) :thumbup:

Bascially where the cowl meets the A pillar both sides is a bit worse for wear on mine. And then just the floor under the rear seats theres some pics in my thread in the 2nd gen section of where I need to repair. The skin on the underside has gone as well as a few repairs needed to the leaf spring pocket mounts.

I can grab photos of specific bits as required :)
Author:  70 z28 [Fri Sep 16, 2011 10:38 pm ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
hi i know the drivers side cowl pannel is realy good but i will check the rest for you tomorow thanks shaun :thumbup:
Author:  flak monkey [Sat Sep 17, 2011 4:10 pm ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
Great thanks.

Need the front section of the passenger side rear frame rail as well. Would save me a shed load of grief. Basically from the spring mount back to where it levels out to go under the boot floor :)
Author:  SoCAZ28 [Thu Nov 17, 2011 5:12 am ]
Post subject:  Re: Anyone breaking a 76-81 Camaro?
See "81 Z/28 Donor car" in Gen II. Figure out how to get it and you can have it...I don't want any money for it, but it just might be cost-prohibitive to get it to you....
Page 1 of 1 All times are UTC
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/