| The Camaro Club (UK) http://classiccamaroclub.mfatw.com/ |
|
| 3rd Gen Panels and Exhaust bits http://classiccamaroclub.mfatw.com/viewtopic.php?f=16&t=1140 |
Page 1 of 1 |
| Author: | Dave c [Mon May 03, 2010 8:46 am ] |
| Post subject: | 3rd Gen Panels and Exhaust bits |
I'm after a drivers side door and drivers side wing. Can any one help? As long as it has no holes I'm probably interested. I also need a Y pipe for a V8, I've got some Flowtech Shorty headers I'm not sure if a standard one would fit? The one on there is a horribly chopped about standard one, hence the need to replace it. |
|
| Author: | Rocky [Mon May 03, 2010 1:42 pm ] |
| Post subject: | Re: 3rd Gen Panels and Exhaust bits |
Will see what I have, I do new Stainless y-pipes but I should think you will need one for your actual headers. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|