Got a selection of 350 SBC bits and bobs needing a new home. All can be collected from near Wisbech. Open to offers on it all - if not sold by end of next week it's all going on eBay! Any questions ask...
Complete bolt on TBI kit, including manifold, throttle body, distributor, coil, all sensors, ECU, brand new Painless 60101 wiring harness ($400!), speed sensor, fuel lines, HT leads etc. Collection only. £250 lot
http://www.summitracing.com/parts/prf-60101
Pair of heads, casting number 10110810. 65cc chambers, 1.94/1.5 valves, complete with springs, rockers (not in photo). Collection only. £70
350 One piece rear main seal crank. Journals are all good, just need a quick polish up. Best for collection. £50
Viscous fan, reverse rotation version. £15 plus carriage
Pair of Flowtech street rod shorty headers. Brand new, with gaskets and weld on flanges and pipe stub to adapt existing systems. Real Steel part number BY11000 (£150). £100 plus post
Set of rods and pistons. For 4.040" bore (yes +0.040"!). All good useable condition, don't look like they have done a lot of miles since being fitted. Sorry no photo of these. £50 plus carriage
Brake servo. Second gen Camaro but will fit other models. Was a new recon unit when fitted, did about 200 miles before being swapped for Hydroboost. £35 plus carriage
2.42 posi axle from Second Gen Camaro/Transam/Firebird. Complete with axle shafts and brake backing plates but no brakes. Doesn't whine or make any silly noises. £225 collection only
