The Camaro Club (UK) http://classiccamaroclub.mfatw.com/ |
|
Third gen parts for sale http://classiccamaroclub.mfatw.com/viewtopic.php?f=15&t=2264 |
Page 1 of 1 |
Author: | Scrapyard_Dog [Mon May 07, 2012 11:14 pm ] |
Post subject: | Third gen parts for sale |
I've downgraded the restoration dreams for my Iroc from an expensive, thorough project to just getting the damn thing done ASAP! Need cash for a respray and I've decided on the bits I don't need so here goes... A TPI set up off a 1988 Iroc-z. Included is plenum, runners (one set has a couple of slight dents), a set of used injectors and fuel rails. I have other parts I can include like dizzy and wiring loom if needed. £150. Driver's door in as close to mint condition as you're likely to find nowadays. No rust and only light surface marks from having been moved and stored. £100 Passenger door from same vehicle in similar condition but has small surface rust scab smaller than 5p piece by the door lock. £100. Next up a pair of Iroc-z fog lights. These are rare and can be expensive to get hold of. These are lacking the thin metal surrounds which always rot away but can be fitted as is. £50. Pair of tail lights for base Camaro. £10. Reply to the thread or drop me a PM if interested. Parts are stored in Herefordshire - delivery of the smaller stuff between here and Maidstone is possible! Cheers... |
Author: | Rocky [Tue May 08, 2012 7:48 am ] |
Post subject: | Re: Third gen parts for sale |
Where abouts are you? |
Author: | Scrapyard_Dog [Tue May 08, 2012 9:16 am ] |
Post subject: | Re: Third gen parts for sale |
Just outside Ross-on-Wye, mate. As I say - I go down to Maidstone pretty much every other weekend so can meet anywhere on route to deliver anything but the doors! |
Author: | Scrapyard_Dog [Tue May 08, 2012 11:01 am ] |
Post subject: | Re: Third gen parts for sale |
Painless loom now provisionally sold... |
Author: | Rocky [Tue May 08, 2012 9:09 pm ] |
Post subject: | Re: Third gen parts for sale |
I would be after everything except the rear lights but not sure if I could get someone to pick it up? Whats your postcode? |
Author: | Scrapyard_Dog [Tue May 08, 2012 10:45 pm ] |
Post subject: | Re: Third gen parts for sale |
PM sent |
Page 1 of 1 | All times are UTC |
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |