The Camaro Club (UK) http://classiccamaroclub.mfatw.com/
89 Camaro door seal ? http://classiccamaroclub.mfatw.com/viewtopic.php?f=15&t=2166	Page 1 of 1

---

Author:	neil.w [Wed Feb 01, 2012 12:06 am ]
Post subject:	89 Camaro door seal ?
Hi guys can any one tell me the best place to get outer door to glass seals for my 89 third gen .Cheers Guys P.S. The black (PLASTIC ) has now gone after 7 hours to get off inc the glue it was a real pain!!!,i see why it was on, someone had sprayed it but must have rubbed the primer down,with a brick ,it must have been a facing brick looking at the scratches once again cheers

---

Author:	camaro85iroc [Wed Feb 01, 2012 12:39 am ]
Post subject:	Re: 89 Camaro door seal ?
are these what your looking for http://www.ebay.co.uk/itm/82-92-CAMARO- ... 4cfe14f90b

---

Author:	neil.w [Wed Feb 01, 2012 11:09 pm ]
Post subject:	Re: 89 Camaro door seal ?
Hi and thank,s for the reply thats what i was looking for ,they are not cheap are they mine dont look to good and im going to respray it and need to change bits like this for it to be worth while Cheers Neil

---

Author:	camaro85iroc [Wed Feb 01, 2012 11:40 pm ]
Post subject:	Re: 89 Camaro door seal ?
i had to get mine from the usa after a lot of hunting about, they are expensive over here and if you hunt about on the usa ebay you,ll find them cheap i got mine for £35 with £20 postage and a 2week wait but it was worth it in the end they are relatively easy to change(door panels need removing) and they look a 110% better for it . any way good luck

---

Author:	onemanrace [Thu Feb 02, 2012 7:41 pm ]
Post subject:	Re: 89 Camaro door seal ?
I'll need to do mine at some point. A door rebuild is in my cars future at some point, once I've slowly assembled the bits (and cash!) for the front end rebuild (with shocks and bushings all round at the same time....) Seems to be a lot of pricey sets out there for what they are!

---

Page 1 of 1	All times are UTC
Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/