Might be interested in the rear axle...
| The Camaro Club (UK) http://classiccamaroclub.mfatw.com/ |
|
| SBC Engines Gearbox and 67 Camaro stuff http://classiccamaroclub.mfatw.com/viewtopic.php?f=15&t=1449 |
Page 1 of 1 |
| Author: | doombrain [Mon Dec 27, 2010 4:18 pm ] |
| Post subject: | SBC Engines Gearbox and 67 Camaro stuff |
SBC 355 Built by ICE back in 1990s No ICEA074 (original build sheets from ICE available) 4 Bolt mains World Products iron heads (angled plugs) Edelbrock Performer RPM inlet Holley 4150 850 double pumper MSD Distributor GM starter motor Edelbrock short water pump Hamburger oilpan Moroso valve covers (modified here and there!) Fresh bearings, seals fitted, not used since This engine made 307bhp at the wheels, and ran 12.37 in our 3000lbs Camaro with the TH350 listed below and 4.11 gears £2250 TH350 by TCI Manual reverse pattern valve body JW Ultra Bell in SFI 2400 stall torque converter. £750 SBC 350 from 1974 Camaro 2 Bolt mains (we think) Edelbrock Aluminium heads Comp roller tipped rockers Holley inlet Holley 650 Vac Sec HEI Distributor GM starter motor Stock long water pump Stock Gen 2 Camaro oilpan This engine came from a car, which we broke for spares, was running but little else known £1500 Headers for 1967 Camaro SBC, wrapped, a bit knocked about, altered to suit angle plug heads £100 Copper radiator from 1967 Camaro SBC with cowl for 15” ish electric fan £50 1974 Camaro 10 bolt axle Open diff 3 something gears All brakes complete £150 Wolfrace Slot Mags 14” Chevy pattern Set of 4 Fair tyres £150 American Racing Daisy Mags 15” Chevy pattern Set of 4 Rears fitted with MT Drag ET`s 28 x 10.5 wide plenty of RWYB left in them. £300 Monoleaf springs for 1967 Camaro (used) with shackles £100 Homemade ladder bars for 1967 Camaro with subframe connector frame (have photos of how it fitted my car) £50 Koni Classic 1967 Camaro front shocks 60 runs £40 Camaro rear drum brakes 12 bolt small ends mounting Shoes relined £50 1967 Camaro “A” arms top and bottom Good ball joints Energy Suspension Polybushed Spindles for disc brakes Standard ride height £150 Blue Holley Pump Well used £20 Viewing preferred and can be anytime. Call Simon Parker on 07980 294675 or email simon.parker@fsmail.net All plus carriage at cost or collect from Melton Mowbray Leicestershire. |
|
| Author: | chevy-stu [Tue Dec 28, 2010 3:24 am ] |
| Post subject: | Re: SBC Engines Gearbox and 67 Camaro stuff |
Might be interested in the rear axle...
|
|
| Author: | 70 z28 [Tue Dec 28, 2010 5:17 pm ] |
| Post subject: | Re: SBC Engines Gearbox and 67 Camaro stuff |
hi i am intrested in the koni front shocks i will ring you tomorow. |
|
| Page 1 of 1 | All times are UTC |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|